Resu Steering Wheel Audio Remote Installation and Setup Guide
Ready to upgrade your old car with modern audio controls? This step-by-step guide will show you exactly how to install your Resu Steering Wheel Audio Remote in minutes — no messy wiring or special tools needed.
Video Guide
Detailed Installation Instructions
1 - Align The Remote
Before we start, you must determine where on your wheel you will place the media remote.
Mock up the remote with the housing to identify the correct angle. We recommend placing a small mark on the rear of the housing and remote to help with alignment later!
2 - Align the Battery Cover
This step is optional but often helps ensure a smoother install. Sometimes the battery cover on the remote isn’t perfectly centered, which can create a small lip or uneven edge.
To fix this, place the remote on its side and gently roll it along its rounded face — this will help center the back cover for a snug, flush fit.
3 - Install the Audio Remote
Place the housing face down on a solid, flat surface with a towel (or other soft material) underneath to protect the finish.
Align the marks you made earlier, then press the remote into the housing firmly with your thumbs until it fully seats.
This is a tight press fit, and you will need to use a considerable amount of force.
That’s it, job done!
Ready TO learn More?
For Bluetooth pairing instructions, view this page:
https://www.resu.net.au/blog/connecting-to-the-bluetooth-audio-remote
Learn about the buttons on your remote here:
https://www.resu.net.au/blog/get-to-know-your-media-controller
